Description

Commonly referred too as the ‘9mm’ profile. Perfect for hinge gap protection and protection where the over travel distance or ‘crushing’ of the profile itself is not required to absorb impact.

This is a GLUED TOGETHER, T FOOT edge. The aluminum is visible after installation. This profile is available to purchase in 25m rolls and assemble yourself or give us your edge requirements and we will pre-assemble the edge(s) for you.

This profile uses the AL15-9 aluminium edge as detailed below – for further technical data and dimensions, see documents above.

Part numbers

SKL15/mtr – SKL15-9 – 9mm Safety edge rubber profile | This profile is available in 25m rolls
KS2W – KS2W 8.2Kohm resistor for SKL15-9 profile
KS2L0.5m – KS2L0.5m Cable end with end cap – 0.5m of cable
KS2L2.5m – KS2L2.5m Cable end with end cap – 2.5m of cable | This is our standard cable end we would use

SBK20 – 2m of heat shrink for sealing ends

Pre made safety edges

Give us the length and profile that you require and we will make your ASO resistive edges for you and send to your address, or even to site.

Order the following codes for pre-made safety edges (SKL 9mm profile):
SKL151.0m – Up to 1.0m 9mm profile safety edge – res or thru
SKL151.5m – Up to 1.5m 9mm profile safety edge – res or thru
SKL152.0m – Up to 2.0m 9mm profile safety edge – res or thru
SKL152.5m – Up to 2.5m 9mm profile safety edge – res or thru
SKL153.0m – Up to 3.0m 9mm profile safety edge – res or thru
*Longer sizes are available on special request